Highest-load low-profile male clip (15 kg), screw-fixed with 3 screws. For heavy wall panels where space is minimal.

$1.36 Tax included

Screw-fixed low-profile male clip (10 kg): fixed to the panel with 3 screws. For heavier plywood or MDF panels.

$1.31 Tax included

Low Profile installation and removal tool kit. Everything needed to fit and take off low-profile panelling.

$174.45 Tax included

Thread tap to cut the clip thread in hard materials, so the male clip fits afterwards. A Fastmount installation tool.

$114.07 Tax included

Tool to install the low-profile female clips by drill/screwdriver. A Fastmount mounting accessory.

$17.00 Tax included

Low Profile installation tool: to set the low-profile clips into position. A Fastmount mounting accessory.

$78.02 Tax included

Standard-range installation tool with depth gauge. To drill the clip holes with precise depth control.

$193.51 Tax included

Tool to remove painted and pre-finished panels without marking the finish. A Fastmount maintenance accessory.

$84.34 Tax included

Thread tap to cut the clip thread in the hole. A Fastmount installation tool.

$234.12 Tax included

One-step drill to make the clip mounting hole. A Fastmount installation tool.

$187.25 Tax included

Countersink bit to chamfer the entry edge of the clip hole. A Fastmount finishing tool.

$167.81 Tax included

Tool to drive the self-tapping male clips into their hole. An installation tool for the Fastmount ranges.

$67.19 Tax included

Drill gauge to precisely control the blind hole depth. An accessory for the CT-09 bit.

$195.25 Tax included

Drill bit for 10 mm blind holes in the back of the panel, without going through. A Fastmount installation tool.

$62.02 Tax included

Step drill to make the clip's 10 mm hole. A Fastmount installation tool.

$174.67 Tax included

List of products by supplier Fastmount